Module 02 · Basic Bookkeeping Skills

How to Build a Chart of Accounts for a Small Business

Chart of accounts numbering system for small business: 1000 to 5000 blocks for each category, gaps of ten between accounts, and room to add more later.

5 min readLesson 4 of 14 in this moduleUpdated 2026-08-25

A chart of accounts for a small business is the numbered list of every account it uses to record transactions — organized into five fixed categories so that a $40 fuel receipt and a $40,000 supplier invoice both have one, and only one, obvious place to go. Get this list right early and every journal entry, report, and tax filing afterward becomes easier. Get it wrong, or skip it entirely, and every transaction becomes a small judgment call that different people will make differently.

Key takeaways

  • A chart of accounts groups every account into five categories: assets, liabilities, equity, revenue, and expenses.
  • Each category gets its own number range, so an account's type is obvious from its number alone.
  • Small businesses typically need 40 to 80 accounts total — add new ones only when a report genuinely needs the split.
  • Leave gaps within each number range so new accounts can be inserted later without renumbering everything.
  • The chart of accounts is the structure; the general ledger is where the actual transaction detail and balances live inside that structure.

What is a chart of accounts?

A chart of accounts is the complete, organized list of every account a business uses, grouped into five categories that map directly onto the accounting equation: Assets = Liabilities + Equity, plus Revenue and Expenses, which explain how trading changes that equity over time. Every transaction has to be recorded against one or more accounts from this list — it's the filing structure everything else in the books depends on.

The five account categories

Each category has a normal balance — the side, debit or credit, where its balance naturally sits and grows.

Category Normal balance Typical accounts
Assets Debit Cash, Bank, Accounts Receivable, Inventory, Equipment
Liabilities Credit Accounts Payable, Bank Loan, Unpaid Wages
Equity Credit Owner's Capital, Retained Earnings
Revenue Credit Sales, Service Revenue
Expenses Debit Rent Expense, Wages Expense, Utilities Expense

One account sits inside equity but behaves the opposite way: Owner's Drawings. It reduces the owner's claim on the business, so — unlike every other equity account — it carries a normal debit balance. It still belongs under Equity in the chart of accounts; it's just the one line in that category that moves in reverse. Understanding why comes down to the debit and credit rules that govern every account type.

A numbering system that scales

Most small businesses number accounts in blocks of a thousand, one block per category:

Range Category
1000–1999 Assets
2000–2999 Liabilities
3000–3899 Equity (capital, retained earnings)
3900–3999 Contra-equity (Owner's Drawings)
4000–4999 Revenue
5000–5999 Expenses

The point of leaving gaps — 1010, 1020, 1030 instead of 1001, 1002, 1003 — isn't tidiness. It's so that a new account, discovered to be genuinely necessary two years from now, can be inserted at 1015 without renumbering every account after it and breaking every historical report that referenced the old numbers.

A small business example you can copy

Here's a starter chart of accounts for a small retail business — Riverside Grocery — with enough detail to actually run the business, and no more:

Number Account Category
1010 Cash Asset
1020 Bank – Checking Asset
1030 Accounts Receivable Asset
1040 Inventory Asset
1050 Equipment Asset
2010 Accounts Payable Liability
2020 Bank Loan Liability
3010 Owner's Capital Equity
3020 Retained Earnings Equity
3910 Owner's Drawings Contra-equity
4010 Sales Revenue Revenue
5010 Cost of Goods Sold Expense
5020 Rent Expense Expense
5030 Wages Expense Expense
5040 Utilities Expense Expense

That's fifteen accounts, and it's already enough to run a simple shop's books and produce a real balance sheet and income statement. A transaction is recorded against these numbers, never against a free-text description:

10 June — Riverside Grocery pays $220 for the month's electricity, by bank transfer
Account Debit Credit
5040 Utilities Expense 220
1020 Bank – Checking 220

Every future utilities payment lands on account 5040 — never split across three inconsistently-named "electricity," "power bill," and "PLN payment" entries that a report can't add together.

How detailed should it be?

Detailed enough to give meaningful information for pricing and tax decisions, not so detailed that entering a transaction becomes a research project. A small business rarely needs more than 40 to 80 accounts in total. Add a new one only when an existing account is genuinely hiding something a report needs to see separately — splitting "Utilities Expense" into electricity and water only makes sense once one of them is big enough, or unpredictable enough, to actually matter to a decision.

Resist the temptation to build out every account a large company might use. A ten-employee business with 200 accounts spends more time deciding where a transaction goes than it does running the business.

Chart of accounts vs general ledger

These two terms get used interchangeably, and they shouldn't be. The chart of accounts is the list — account names and numbers, nothing more. The general ledger is where the actual transactions land and accumulate, account by account, over time. Think of the chart of accounts as the table of contents and the ledger as every page of detail sitting behind it. You design the chart of accounts once, at setup, and add to it rarely; the ledger fills up every single day the business operates.

Can you change it later?

Yes, but carefully. New accounts can be added at any time as the business grows — that's expected and healthy. What causes real damage is renaming, merging, or deleting an existing account partway through a year, because every report that already used the old structure stops being comparable to the reports that come after the change. Save structural edits for the start of a new accounting year wherever you can, and treat mid-year renumbering as a last resort.

Doing this in Reyuko

Reyuko's Chart of Accounts is built directly on the five categories above, extended to a full four-level structure: Level 1 is the five fixed categories (Assets, Liabilities, Equity, Revenue, Expenses), Levels 2 and 3 are system-default classifications you can still adjust, and Level 4 is the actual account you post transactions against — auto-numbered so no two accounts can collide. System-default accounts can be locked so they can't be accidentally deleted or renamed mid-year, and every transaction posted from Sales, Purchase, or the General Ledger is required to sit under one of these five categories — there's no way for an account to exist outside the structure. This is all part of Reyuko's free edition.

Build your own in 15 minutes

Grab a blank page and:

  1. Write the five categories: Assets, Liabilities, Equity, Revenue, Expenses.
  2. Under each, list only the accounts your business genuinely uses today.
  3. Assign a number from the correct range to each, leaving gaps of ten.
  4. Add Owner's Drawings as a contra-equity account with a number just outside your normal equity range.
Show what a finished starter list looks like

If your list resembles the fifteen-account Riverside Grocery example above — a handful of asset, liability, and equity accounts, one revenue account, and four or five expense accounts — you have a working chart of accounts ready to record real transactions against.

Frequently asked questions

How should I number accounts in a chart of accounts?

Give each category its own block: 1000 to 1999 for assets, 2000 to 2999 for liabilities, 3000 to 3899 for equity, 3900 to 3999 for contra-equity such as owner drawings, 4000 to 4999 for revenue and 5000 to 5999 for expenses. Within each block, space accounts ten apart, so the first digit tells you the category at a glance.

When is a new account worth adding to the chart?

Most small businesses need about 40 to 80 accounts in total. Add a new one only when an existing account hides something a report needs to see separately. Splitting utilities into electricity and water only makes sense once one of them is large enough, or unpredictable enough, to affect a decision.

Do account codes need more than four digits?

Four digits is enough for a paper or spreadsheet chart. The first digit names the category, so 1 means an asset and 5 means an expense, and the remaining three digits leave room for gaps of ten. Those gaps also let you insert a new account later without renumbering the others.

Can I choose my own account numbers in Reyuko?

Reyuko suggests the next number when you add a Level 4 account, and you can adjust it before saving; after that the code is fixed. Reyuko's codes follow its own format, for example 1-1005, so the 1000 to 5999 scheme above suits a paper or spreadsheet chart. The five top-level categories are fixed to the accounting equation, and the Chart of Accounts is part of the free edition.

Can I add an account under a category later in Reyuko?

Yes. Add Level 4 accounts when a report needs a split, and Reyuko keeps each one under one of the five fixed categories. System-default accounts can be locked, so they cannot be deleted or renamed by accident in the middle of the year.

Start from a structure, not a blank ledger

Reyuko's Chart of Accounts locks the five top-level categories to the accounting equation and auto-numbers every account you add, so nothing can exist outside the structure.

Download Reyuko freeSee what's included